The ultrasonic vibratory separator is an organic combination of an ultrasonic controller and a vibrating screen. It converts 220V, 50Hz or 110V, 60Hz electrical energy into 18kHz high frequency electrical energy, introduces an ultrasonic transducer, and switches to mechanical vibration around 15kHz to reach the screen. , Purpose of cleaning the screen. High-frequency ultrasonic waves with small amplitude are superimposed on the screen to greatly accelerate the ultrafine powder, thereby suspending the screen material, causing adhesion, friction and other factors to block the screen, preventing problems before they occur. Therefore, the screening problem can be effectively solved. Now it is not difficult to screen ultra-fine powder, which is especially suitable for users of high-quality fine separation. Irregular shapes are screened out; the net cleaning device can effectively solve the blockage problem; there is no network blockage or dust scattering phenomenon; impurities and thick materials are automatically removed and can work continuously; unique mesh design, long service life of the screen cloth. Change the grid in minutes. Common faults and remedial measures of ultrasonic vibratory separator If the engine is damaged, the engine can be replaced; the electrical components of the control line are damaged and the electrical components can be replaced; the voltage is insufficient, and the power supply can be replaced; if the accumulated material is too much, you can use clean materials to clean Method; when the vibrator is not working, use the vibrator repair method; if the fat in the vibrator becomes sticky, use the vibrator cleaning method and add appropriate fat; if the ultrasonic controller does not work, please check the connection Whether the parts are tight. If you find them loose, tighten them. Common errors and solutions of ultrasonic shielding systems. The ultrasonic vibration power supply is not displayed, and the ultrasonic device does not work. When working, it is necessary to check whether the 220V power cord is disconnected, and repair and replace if there is a problem. Check the safety tube of the ultrasonic vibration power supply. If it is normal, replace it with the switch of the power adapter. If there is a problem, please replace it. If the ultrasonic power supply is continuous or intermittent, please check the connection between the ultrasonic vibrator power supply and the transducer, and replace it if there is a circuit. Check the connectors for water, wet materials or pipes. Short circuit, repair and check the time. Check the insulation value of cables and connectors. If the resistance is less than 1 MΩ, replace the connector. Check if the sensor is blocked. Repair at the factory; The amplitude of the power supply of the ultrasonic vibration separator is small, and the amplitude of the shield is weak. Check the insulation of the cable and the connector. Check the sensor. If the sensor is not blocked, tighten the sensor with a large wrench. If the screen is tight and the adhesive is exposed, squeeze the screen or stretch the screen. Check for dirt between the sensor and the bottom of the frame. Cracks that cause frequency mismatch. Above we introduced the vibratory separator. The HENAN EXCELLENT MACHINERY CO., LTD is a professional bulk material conveying equipment manufacturer. We have a professional production capacity and rich production experience as well as strict product quality inspection. We can guarantee that every piece of equipment we produced is qualified equipment, and we ensure the qualified rate of the products. To know more about our products, Please visit our official website: https://m.exctmach.com/.